P0917
Gear Shift Position Circuit A High
Set when the gear shift position signal on circuit A of an automated manual gearbox stays above its highest valid value for longer than a calibrated time. The signal line may be shorted to the sensor supply or to battery voltage, the sensor ground may be open, or the sensor itself may be faulty. No manufacturer documents this code publicly. The Aisin AI and Nissan/Aichi patents show the shift stroke or shift position sensor as the feedback that confirms an engaged gear; with a reading above the valid band the controller can no longer tell neutral from an engaged gear. CARB requires out-of-range checks on such inputs. P0916 is the opposite low fault, P091D and P095D are the high faults of circuits B and C, P0919 a shift movement that misses its target. Shifting is usually locked.
Possible causes
- Signal wire shorted to sensor supply or battery voltage high
- Open sensor ground or corroded ground pin medium
- Internal fault of the shift position sensor medium
- Faulty input stage in the transmission control module low
Symptoms
- Check engine or transmission warning light on
- Gearbox stays in one gear or in neutral
- Warning message about the transmission on the dashboard
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P0917
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.