P0915
Gear Shift Position Circuit A Range/Performance
Plausibility fault of the gear shift position signal on circuit A in an automated manual gearbox. The voltage stays within its electrical limits, but the reading does not fit: the signal does not change while the shift actuator moves, or the engaged position does not match the learned gear positions. No manufacturer documents this code in freely citable material. A Nissan/Aichi patent points out that sensor brackets on shift forks can deform under vibration and spoil the reading, and an Aisin AI patent describes the fallback when a stroke sensor can no longer be trusted. CARB requires rationality checks on such inputs. P0914, P0916 and P0917 are the electrical faults, P0919 a shift movement that misses its target. Shifting becomes limited or stops.
Possible causes
- Worn or drifting shift position sensor, redundant tracks disagree high
- Bent sensor bracket or displaced magnet on the shift rod medium
- Gear positions not relearned after actuator or TCM replacement medium
- High resistance at connector pins distorting the signal low
Symptoms
- Check engine or transmission warning light on
- Gearbox drops to neutral while driving
- Gears refused or engaged only after a delay
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P0915
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.