OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0912

Gate Select Actuator Circuit Low

Set when the drive circuit of the gate select actuator of an automated manual gearbox shows a voltage that is too low for the current switching state, which usually means a short to ground on a motor or control line, or an internal short in the actuator. Many controllers then switch the affected output off to protect the driver stage. No manufacturer documents this code publicly. Isuzu and Hyundai/Kia describe in their patents select and shift actuators built as electric motors and driven by the transmission controller, which is the hardware this circuit check covers; CARB requires circuit monitoring of such outputs. P0913 is the matching high fault, P0910 an open circuit and P0911 a plausibility fault. With the select actuator disabled, the gearbox can no longer change gates.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number9 / 12

Possible causes

  • Actuator wire chafed through and shorted to ground high
  • Internal short in the select motor, e.g. from brush debris medium
  • Faulty driver stage in the transmission control module low

Symptoms

  • Check engine or transmission warning light on
  • No gate change possible, gearbox stays in current gear or neutral
  • Vehicle may not pull away

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P0912

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication