P0911
Gate Select Actuator Circuit Range/Performance
Plausibility fault in the drive circuit of the gate select actuator of an automated manual gearbox. The circuit is neither open nor shorted, but the current, voltage or response measured on it does not fit the command, for example a current that is too high or too low for the requested movement. No manufacturer documents this code publicly. A Hyundai/Kia patent explains why controllers watch actuator current closely: jamming and sticking raise the motor load, and the motor can be damaged if this is not caught early. An Isuzu patent describes electric select actuators controlled by the transmission module. CARB requires functional checks on such outputs. P0910, P0912 and P0913 are the clear electrical faults, P0909 the failure to reach a gate. Gear changes become slow or are blocked.
Possible causes
- Worn select motor drawing abnormal current high
- Stiff select mechanism overloading the actuator medium
- High resistance in actuator wiring or connector medium
Symptoms
- Check engine or transmission warning light on
- Slow, hesitant or aborted gear changes
- Gearbox enters fallback mode with limited gears
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P0911
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.