P0910
Gate Select Actuator Circuit/Open
Concerns the drive circuit of the gate select actuator, the motor or valve that moves the shift mechanism of an automated manual gearbox sideways from gate to gate. The code sets when the control module finds this output open or electrically faulty, for example when no current flows although the driver stage is switched on. No manufacturer documents this code publicly. Isuzu and Hyundai/Kia patents describe select and shift actuators as electric motors fed by the transmission controller; older and heavy-duty systems use hydraulic or pneumatic select cylinders with solenoid valves. CARB requires circuit checks on such outputs. P0911 to P0913 are the range, low and high variants, P0909 a select movement that misses its target. Without the select actuator the gearbox cannot change gates and stays in its current gear or neutral.
Possible causes
- Open winding or worn brushes in the select motor high
- Broken actuator wire or terminal pushed out of the connector medium
- Corroded actuator connector near the gearbox medium
- Faulty actuator driver stage in the transmission control module low
Symptoms
- Check engine or transmission warning light on
- Gearbox cannot change between gates, only some gears available
- Vehicle may stay in neutral and not drive off
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P0910
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.