OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0908

Gate Select Position Circuit A Intermittent

Points to a gate select position signal on circuit A that drops out or jumps for short moments in an automated manual gearbox, too briefly or too irregularly for a steady low or high fault. Loose terminals, a damaged harness that moves with the engine, or moisture in the connector at the shift and select actuator are the usual reasons. No manufacturer documents this code publicly. An Aisin AI patent explains why even short sensor dropouts matter: if a stroke sensor fails while driving, the controller can no longer confirm the engaged gear and must switch to a fallback strategy. CARB requires circuit and rationality checks on such inputs. P0904 to P0907 are the steady faults of the same circuit. Drivers often notice occasional neutral drops or refused shifts that vanish again.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number9 / 08

Possible causes

  • Loose or spread terminals at the sensor or actuator connector high
  • Harness damage that only opens or shorts under engine movement medium
  • Moisture or corrosion in the connector near the gearbox medium

Symptoms

  • Warning light that comes and goes
  • Occasional drop to neutral or refused shift
  • Fault often disappears after restarting the engine

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P0908

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication