OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0907

Gate Select Position Circuit A High

Set when the gate select position signal on circuit A of an automated manual gearbox stays above its highest valid value for longer than a calibrated time. Typical causes are a short of the signal line to the sensor supply or to battery voltage, a broken sensor ground, or an internal sensor fault. No manufacturer documents this code publicly. The patents of Aisin AI and Isuzu on select control show that the module derives the active gate directly from this sensor voltage, so a reading above the valid band leaves it blind in the select direction; CARB requires out-of-range checks on such inputs. P0906 is the opposite low fault, P09A5 and P09A9 are the high faults of circuits B and C. For the driver this usually means a warning lamp and a gearbox that no longer changes gear or stays in a fallback gear.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number9 / 07

Possible causes

  • Signal wire shorted to sensor supply or battery voltage high
  • Open sensor ground or corroded ground pin medium
  • Internal fault of the gate select sensor medium
  • Faulty input stage in the transmission control module low

Symptoms

  • Check engine or transmission warning light on
  • Gearbox stays in one gear or in neutral
  • Engine may not start because neutral cannot be confirmed

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P0907

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication