OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0906

Gate Select Position Circuit A Low

Set when the gate select position signal on circuit A of an automated manual gearbox stays below its lowest valid value for longer than a calibrated time. Common causes are a short to ground on the signal line, a missing sensor supply, or an internal sensor defect; with many sensor designs a broken signal wire also reads low. No manufacturer documents this code publicly. Aisin AI and Isuzu describe select stroke and select position sensors with a defined voltage curve across the gates in their patents, so a value below that curve is clearly out of range; CARB calls for out-of-range checks on such inputs. P0907 is the matching high fault, P09A4 and P09A8 are the low faults of circuits B and C. Without a gate signal the gearbox usually locks gear changes or holds a safe gear.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number9 / 06

Possible causes

  • Signal wire chafed through and shorted to ground high
  • Sensor reference supply interrupted or shorted medium
  • Internal defect of the gate select sensor medium
  • Faulty input stage in the transmission control module low

Symptoms

  • Check engine or transmission warning light on
  • No gear changes possible or gearbox stays in neutral
  • Warning message about the transmission on the dashboard

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P0906

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication