P0904
Gate Select Position Circuit A
Circuit A of the gate select position sensor tells the control module of an automated manual gearbox where the shift mechanism stands in the select direction, i.e. which gate (for example 1-2, 3-4, 5-6 or reverse) is lined up. This generic circuit code sets when the module sees an electrical fault on that signal that is not covered by the more specific low, high or intermittent variants. No manufacturer documents the code publicly. Aisin AI and Isuzu patents describe such select stroke or select position sensors working next to an electric or hydraulic select actuator, and CARB requires circuit checks on transmission inputs of this kind. P0905 to P0908 are the siblings, P09A2 and P09A6 the same signal on circuits B and C. Without a valid gate signal the gearbox usually stops shifting or holds one gear.
Possible causes
- Loose, corroded or water-damaged connector at the gate select sensor or actuator unit high
- Chafed or broken sensor wiring near the gearbox medium
- Faulty gate select position sensor (often integrated in the shift and select actuator) medium
- Faulty sensor input or reference supply in the transmission control module low
Symptoms
- Check engine or transmission warning light on
- Gearbox stops shifting or stays in one gear
- Neutral indicator flashes or vehicle will not pull away
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P0904
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.