P0901
Clutch A Actuator Control Circuit Range/Performance
Set when the clutch A actuator circuit is electrically present but does not behave as expected, for instance when the measured current or response deviates too far from the target. Usage differs by maker. Ford lists P0901 among the DPS6 PowerShift codes, and trade guidance recommends swapping the two identical clutch motors: if the fault moves to clutch B, the motor is bad. Honda added P0901 on the 2015 TLX V6 nine-speed automatic for abnormal resistance in the clutch pressure control solenoid circuits, with failsafe gear hold and MIL. FCA recall 16V529 on 9-speed models also uses it to decide on a harness replacement. P0900, P0902 and P0903 are the pure circuit faults; P090B is the clutch B counterpart.
Possible causes
- Weak or worn clutch A actuator motor (dual-clutch units) high
- High resistance in the transmission harness or sub-harness medium
- TCM fault or outdated TCM software low
Symptoms
- Check engine light on
- Shudder, harsh engagement or missed shifts
- Failsafe mode with a held gear
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P0901
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.