P08ED
Drive Motor A Clutch Pawl Position Performance
A plausibility fault: the pawl position reported for the drive motor A disconnect clutch does not match what the control module commanded, or the clutch did not reach the expected position, even though the circuit itself is electrically intact. GM documents the code for the 2024 Corvette E-Ray, whose front electric drive unit uses a clutch pawl and a disconnect clutch actuator; bulletin 24-NA-165 says it is stored in the drive motor control module, lights the MIL and is usually caused by the disconnect clutch switch, which is replaced as an external part. Electrical faults of the same signal are P08EA to P08EC; actuator enable faults are P08E7 to P08E9. The driver mostly sees the warning lamp and loss of electric front drive.
Possible causes
- Faulty drive motor disconnect clutch switch (GM E-Ray bulletin) high
- Disconnect clutch actuator not moving the pawl fully medium
- Worn or binding pawl or clutch teeth inside the drive unit low
Symptoms
- Malfunction indicator lamp on
- Electric front-axle drive unavailable or intermittent
- Hybrid modes restricted
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P08ED
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.