OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P08EC

Drive Motor A Clutch Pawl Position Circuit High

Set when the pawl position signal of the drive motor A disconnect clutch stays above its valid range. Typical reasons are an open signal or ground wire, which lets the input float high, or a short to a supply voltage. The module then has no trustworthy feedback on whether the clutch is engaged. No manufacturer documents this code publicly; the closest documented hardware is the disconnect clutch switch on the Corvette E-Ray front drive unit, tied by GM only to P08ED, and patents on pawl or strut clutches with position sensors show the principle. CARB requires out-of-range monitoring. P08EB is the low-side fault, P08EA the general circuit fault, P08ED the plausibility check. Electric drive on that axle is usually locked out.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number8 / EC

Possible causes

  • Open signal or ground wire of the position switch high
  • Signal wire shorted to a supply circuit medium
  • Position switch or sensor failed high medium

Symptoms

  • Check engine light or hybrid system warning on
  • No electric drive from the affected axle
  • All-wheel drive or electric launch missing

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P08EC

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication