P08EB
Drive Motor A Clutch Pawl Position Circuit Low
Set when the pawl position signal of the drive motor A disconnect clutch stays below its valid range, which points to a short to ground in the signal wire, a missing sensor supply or a sensor that has failed low. The module then cannot tell whether the pawl has engaged. No manufacturer documents this code publicly; the matching hardware is the disconnect clutch switch on the front drive unit of the Corvette E-Ray, which GM links only to P08ED, and supplier patents describe such position sensing on pawl or strut clutches. CARB requires out-of-range checks on these inputs. P08EC is the high-side fault, P08EA the general circuit fault. The system typically keeps the motor uncoupled and lights a warning.
Possible causes
- Position signal wire shorted to ground high
- Missing supply voltage to the position switch medium
- Position switch or sensor failed low medium
Symptoms
- Check engine light or hybrid system warning on
- Electric drive axle disabled
- Hybrid modes with electric assist not selectable
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P08EB
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.