OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P08EA

Drive Motor A Clutch Pawl Position Circuit

Concerns the sensor or switch that reports where the pawl of the drive motor A disconnect clutch sits, i.e. whether the form-locking clutch is engaged or released. The code sets when the control module finds an electrical fault in that signal circuit, such as an open line or a signal outside its valid states. No manufacturer documents this code publicly. GM fits a drive motor disconnect clutch switch to the front drive unit of the Corvette E-Ray and blames it for P08ED; pawl clutches with dedicated position sensors are described in supplier patents such as one from Means Industries. CARB requires input circuit checks. P08EB and P08EC are the low and high variants, P08ED the plausibility fault. Electric drive on that axle is usually inhibited.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number8 / EA

Possible causes

  • Faulty disconnect clutch position switch or sensor high
  • Open signal or reference wire to the position switch medium
  • Corroded or loose connector at the drive unit medium
  • Faulty input stage in the drive motor control module low

Symptoms

  • Check engine light or hybrid system warning on
  • Electric drive or all-wheel drive unavailable
  • Reduced acceleration in hybrid modes

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P08EA

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication