OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P08E9

Drive Motor A Clutch Enable Circuit High

Set when the enable line of the drive motor A disconnect clutch actuator reads higher than it should, for example because it is shorted to a supply voltage or the line floats due to an open ground. The module then cannot reliably switch the actuator off or confirm its state. No manufacturer documents this code publicly; the nearest known application is the front electric drive unit of the Corvette E-Ray, whose disconnect clutch actuator and switch GM services as separate parts but describes only under P08ED and a communication code. CARB covers the fault through its output component monitoring. P08E8 is the low-side counterpart, P08E7 the general circuit fault. The system normally keeps the motor uncoupled.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number8 / E9

Possible causes

  • Enable wire shorted to a supply circuit high
  • Open ground or reference circuit of the actuator medium
  • Internal fault in the disconnect clutch actuator medium
  • Faulty output stage in the drive motor control module low

Symptoms

  • Check engine light or hybrid system warning on
  • Electric drive on the affected axle switched off
  • Possible clunk when the system tries to couple the motor

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P08E9

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication