OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P08E8

Drive Motor A Clutch Enable Circuit Low

Set when the voltage on the enable line of the drive motor A disconnect clutch actuator stays below the expected range, usually because the wire or the actuator input is shorted to ground. The control module can then no longer switch the actuator on, so the clutch cannot be engaged or released on command. No manufacturer documents this code publicly; the comparable hardware is the front drive unit of the Corvette E-Ray with its disconnect clutch actuator, pawl and switch, for which GM publishes only P08ED and an actuator communication fault. CARB requires such circuit monitoring. P08E7 is the general circuit fault, P08E9 the high-side counterpart. Electric drive on that axle is typically disabled.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number8 / E8

Possible causes

  • Enable wire chafed and shorted to ground high
  • Internal short at the actuator enable input medium
  • Water ingress in the actuator connector medium
  • Faulty output stage in the drive motor control module low

Symptoms

  • Check engine light or hybrid system warning on
  • Electric drive axle stays disconnected
  • Reduced performance, no electric launch or all-wheel drive

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P08E8

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication