OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P08E7

Drive Motor A Clutch Enable Circuit

Covers the enable line with which a drive motor control module activates the actuator of a clutch that couples or uncouples electric drive motor A from the wheels. The code sets when the module sees an electrical fault on that line, typically an open circuit or an implausible state. No manufacturer documents this code publicly. The closest known hardware is the front electric drive unit of the 2024 Corvette E-Ray, which has a disconnect clutch actuator, a clutch pawl and a position switch; GM lists separate faults there, such as P08ED and a lost-communication code for the actuator. CARB requires circuit checks on such output components. P08E8 and P08E9 are the low and high variants. The driver usually loses electric assist on that axle.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number8 / E7

Possible causes

  • Enable wire open or connector at the clutch actuator not seated high
  • Internal electronics fault in the disconnect clutch actuator medium
  • Corroded or water-damaged connector near the drive unit medium
  • Faulty enable driver in the drive motor control module low

Symptoms

  • Check engine light or hybrid system warning on
  • No electric drive or assist from the affected axle
  • All-wheel-drive or electric-only modes unavailable

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P08E7

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication