P08DA
Shift Solenoid K Control Circuit Range/Performance
Points to a control circuit of shift solenoid K that is neither open nor shorted, yet whose measured values, usually coil current, do not fit the commanded state. No manufacturer documents this code publicly, and the analogue for solenoid A, P0972, is not used in the GM or Ford sources either. Ford covers the same failure with an electrical current check that trips when the feedback current stays out of range for 0.5 seconds. Causes are typically a coil with changed resistance, a high-resistance contact or a weak TCM driver. CARB requires output circuits to be checked beyond plain opens and shorts. P08DB, P08DC and P08DD cover low, high and open. The valve may switch late or incompletely.
Possible causes
- Solenoid coil resistance out of specification high
- Corroded or loose pins adding resistance medium
- TCM output stage no longer delivers correct current low
Symptoms
- Check engine or transmission warning light on
- Delayed or soft shifts
- Possible limp mode
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P08DA
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.