P08D4
Shift Solenoid J Control Circuit/Open
Dedicated code for an open control circuit of shift solenoid J: the TCM drives the valve but no current flows through wire, connector or coil. No manufacturer documents this code publicly. The known analogues show why: Ford files an open circuit under the base code of each solenoid (P0750 for solenoid A) and GM includes it in the high-voltage code P0974, so neither needs a separate open code. Ford detects such electrical faults when driver feedback disagrees with the command for 0.5 to 5 seconds. CARB requires open and short checks on transmission outputs. P08D2 and P08D3 are the short-circuit codes. An unpowered valve rests in its default state, so a gear may be missing or locked.
Possible causes
- Broken control wire or loose terminal high
- Burnt-out solenoid coil medium
- Transmission connector not fully seated after service medium
Symptoms
- Check engine or transmission warning light on
- One gear missing or transmission stuck in one gear
- Harsh shifts
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P08D4
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.