OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P08D2

Shift Solenoid J Control Circuit Low

Set when the TCM sees too little voltage on the control line of shift solenoid J, typically because the line or the coil is shorted to ground. No manufacturer documents this code publicly; J would be a tenth on/off valve, which none of the known transmission sources assigns. GM's analogue for solenoid A, P0973 on the 6-speed units, fails when the output driver reports a ground short for 1.2 of 1.5 seconds and lights the MIL after one trip; Ford names the same fault on its solenoids a short to ground. CARB requires such circuit checks. P08D3 is the high-side fault, P08D4 the open circuit. The TCM usually switches the valve off and runs a substitute gear.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number8 / D2

Possible causes

  • Control wire chafed through and shorted to ground high
  • Solenoid coil with internal short medium
  • Damaged internal transmission harness or lead frame medium
  • Faulty output stage in the TCM low

Symptoms

  • Check engine or transmission warning light on
  • Transmission holds a substitute gear
  • Harsh or missing shifts

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P08D2

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication