OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P08D1

Shift Solenoid J Control Circuit Range/Performance

Set when the control circuit of shift solenoid J is electrically intact but its measured values, usually solenoid current or driver feedback, lie outside the expected window for the commanded state. No manufacturer documents this code publicly. The analogue for solenoid A, P0972, is likewise not used in the GM and Ford sources checked; Ford reports such current faults by its own electrical current check, which flags feedback current out of range for 0.5 seconds. CARB requires output circuits to be checked for faults beyond plain opens and shorts. P08D2 and P08D3 cover low and high circuit voltage, P08D4 an open circuit, P08CF a general electrical fault. Shift quality may suffer because the valve no longer moves as intended.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number8 / D1

Possible causes

  • Solenoid coil resistance out of specification high
  • High resistance at connector pins or internal harness medium
  • Unstable supply voltage to the TCM or solenoid feed low
  • Faulty current sensing in the TCM output stage low

Symptoms

  • Check engine or transmission warning light on
  • Harsh or irregular shifts
  • Possible limp mode

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P08D1

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication