OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P08CE

Shift Solenoid J Stuck On

Set when shift solenoid J is switched off but its clutch or shift valve stays applied, so the valve behaves as if stuck in its on position. No manufacturer documents this code publicly. GM's P0752 on the 6-speed transmissions is the nearest documented counterpart: with third gear commanded, the TCM flags shift solenoid A stuck on when the gearbox slip reaches 400 rpm while first or second gear is actually obtained, and the MIL comes on after one trip. Ford sets its stuck-on codes P0752 to P0772 from the gear or shift pattern actually reached. CARB requires such functional monitoring. P08CD is the opposite fault. Because an applied clutch can tie up the gearbox, drivers may feel a wrong gear, a harsh engagement or limp mode.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number8 / CE

Possible causes

  • Solenoid or its shift valve held in the applied position by debris or varnish high
  • Contaminated transmission fluid after internal wear medium
  • Control circuit shorted so the solenoid stays energised low
  • TCM output driver does not switch off low

Symptoms

  • Check engine or transmission warning light on
  • Wrong gear or harsh engagement, possible binding feel
  • Transmission goes into limp mode

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P08CE

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication