P08CD
Shift Solenoid J Performance/Stuck Off
Set when shift solenoid J is switched on but the gear or clutch it controls does not respond, so the valve behaves as if stuck in its off position. No manufacturer documents this code publicly. The closest documented analogue is GM's P0751 on the 6-speed transmissions: the TCM commands first gear and flags shift solenoid A stuck off when slip reaches 400 rpm with the gear ratio out of window, a two-trip fault. Ford sets P0751 to P0771 when the obtained gear or shift pattern shows a solenoid functionally failed off after three solenoid events. CARB requires this kind of functional check. P08CE is the opposite fault, P08CF and P08D1 to P08D4 cover the circuit. The driver notices slipping, flare or a missing gear.
Possible causes
- Solenoid or its shift valve held in the off position by debris or varnish high
- Low fluid level or weak supply pressure to the valve medium
- Worn clutch pack or leaking seal in the circuit served by the valve medium
- Solenoid coil too weak to move the valve low
Symptoms
- Check engine or transmission warning light on
- Engine flare or slipping during or after a shift
- A gear is missing or skipped
- Transmission may hold a substitute gear
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P08CD
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.