P08CB
Pressure Control Solenoid M Control Circuit High
GM uses this code on the Corvette's Tremec dual clutch for synchronizer actuation valve 1 (odd-gear shaft) in two situations. First, a short to battery voltage: with the low-side driver on, a sense voltage above 0.7, 0.9 or 1.1 V (±0.1 V), depending on supply voltage, counts as a shorted load, confirmed after 150 ms. Second, a short to a neighbouring output: at shutdown every output is switched on in turn, a cross-reaction is stored in memory and the code is set at the next start. Type A, MIL at once. The check pauses while P0882 or P0883 is present. A valve shorted to power cannot be switched off, so the transmission will usually go into a fallback mode.
Possible causes
- Control wire shorted to battery voltage high
- Short to an adjacent solenoid wire in the internal harness medium
- Defective driver stage in the transmission control module low
Symptoms
- Check engine light on immediately
- Fallback mode with restricted gears
- Code may appear right after starting
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P08CB
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.