P08CA
Pressure Control Solenoid M Control Circuit Low
GM sets this code on the Corvette's Tremec dual clutch for a short to ground in the circuit of synchronizer actuation valve 1, which serves the odd-gear shaft. The test runs while the low-side driver is switched on: the sense pin should then sit at a defined level, and if the driver chip reports it below about 1.7 V (±0.5 V), a ground short is assumed. Confirmation takes 150 ms at 8.75 to 18 V battery voltage with the engine not cranking, and the check is suspended when P0882 or P0883 is present. Type A, MIL at once, monitored continuously. Valves 2 to 5 have their own low codes (P27BF onwards). The driver should expect a fallback mode until the wiring fault is repaired.
Possible causes
- Control wire chafed through to ground high
- Shorted turns in the solenoid coil medium
- Fluid in the transmission connector low
Symptoms
- Check engine light on immediately
- Fallback mode with restricted gears
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P08CA
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.