OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P08C8

Pressure Control Solenoid M Control Circuit/Open

GM sets this code on the Corvette's Tremec dual clutch for an open circuit at synchronizer actuation valve 1, the valve for the odd-gear shaft. The open-load test runs with the low-side driver switched off: an intact coil pulls the sense pin to battery voltage, so if the driver chip can hold it between about 1.7 and 3 V (each ±0.5 V) with a very small current, the circuit is considered open. The fault must persist for 150 ms with battery voltage between 8.75 and 18 V and the engine not cranking; it is suspended while P0882 or P0883 indicates a supply problem. Type A, MIL at once. Without this valve the odd shaft cannot be shifted reliably, so a fallback mode is likely.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number8 / C8

Possible causes

  • Connector at the control valve body loose or corroded high
  • Broken wire in the internal harness medium
  • Solenoid coil open medium

Symptoms

  • Check engine light on immediately
  • Fallback mode with restricted gears

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P08C8

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication