P08C6
Pressure Control Solenoid M Electrical
Collective code for an electrical fault of pressure control solenoid M without a finer split into open, low or high. No manufacturer documents it publicly. GM, the documented user of letter M on the Corvette dual clutch (synchronizer actuation valve 1), reports electrical faults only through the specific codes P08C8, P08CA and P08CB, which are derived from the diagnostic status of the low-side driver chip and confirmed after 150 ms. CARB requires a circuit check for every monitored transmission solenoid. A manufacturer setting P08C6 would point to coil, connector or harness of this valve; for the driver this means the warning light and restricted shifting on the affected shaft.
Possible causes
- Solenoid coil open or shorted high
- Damaged connector or internal harness medium
- Faulty driver stage in the transmission control module low
Symptoms
- Check engine light on
- Restricted shifting or fallback mode
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P08C6
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.