OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P08C2

Pressure Control Solenoid L Control Circuit High

Reports a control circuit voltage of pressure control solenoid L that is too high, typically a short to battery voltage or to a neighbouring output. No manufacturer documents this code publicly; Toyota, the one documented user of letter L, has published only P08BA71. GM's equivalent for solenoid M (P08CB) uses two tests: with the low-side driver on, a sense voltage above 0.7 to 1.1 V, depending on supply voltage, means a short to power; at shutdown each output is also switched on in turn to detect a short to a neighbouring output, which is then stored and reported at the next start. A shorted valve usually cannot be switched off. P08C1 is the low counterpart, P08BF the open circuit.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number8 / C2

Possible causes

  • Control wire shorted to battery voltage high
  • Short between adjacent solenoid wires in the internal harness medium
  • Defective output stage in the transmission control module low

Symptoms

  • Check engine light on
  • Transmission in fallback gear

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P08C2

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication