P08C1
Pressure Control Solenoid L Control Circuit Low
Reports a control circuit voltage of pressure control solenoid L that is too low, usually a short to ground. No manufacturer documents this code publicly; Toyota, the one documented user of letter L, has published only P08BA71. GM's equivalent for solenoid M (P08CA) illustrates the check: while the low-side driver is switched on, the sense pin is examined and a value below about 1.7 V is read as a short to ground, confirmed after 150 ms with battery voltage between 8.75 and 18 V. Depending on the wiring, a ground short can energise the valve permanently or make it uncontrollable. P08C2 is the high counterpart, P08BF the open circuit. Expect a fallback gear and the warning light.
Possible causes
- Control wire chafed through to ground high
- Shorted turns in the solenoid coil medium
- Fluid or moisture in the connector low
Symptoms
- Check engine light on
- Transmission in fallback gear
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P08C1
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.