P08BF
Pressure Control Solenoid L Control Circuit/Open
Points to an open control circuit of pressure control solenoid L: the module sees no load where the coil should be. No manufacturer documents this code publicly; Toyota, the only known user of letter L, has published just P08BA71. GM's open-load test for the analogous solenoid M (P08C8) shows the method: with the low-side driver switched off, the coil should pull the sense pin up to battery voltage; if the driver chip can hold it between roughly 1.7 and 3 V with a tiny current, the circuit is open. Confirmation takes 150 ms. P08C1 and P08C2 are the short to ground and short to power. Typical results are a fallback gear and the warning light.
Possible causes
- Connector loose, unplugged or corroded high
- Broken wire in the internal or external harness medium
- Solenoid coil burnt open medium
Symptoms
- Check engine light on
- Transmission in fallback gear
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P08BF
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.