P08BD
Pressure Control Solenoid L Electrical
Collective code for an electrical fault of pressure control solenoid L that the module does not break down further into open, low or high. No manufacturer documents it publicly; Toyota, the one known user of letter L, has only published the stuck fault P08BA71. Manufacturers that diagnose their solenoids in detail use the specific circuit codes instead, as GM does for solenoid M with P08C8, P08CA and P08CB, each fed by the diagnostic status of the output driver chip. CARB requires a circuit continuity check for every monitored transmission solenoid. The usual culprits are coil, connector or the internal harness; the driver sees the warning light and, depending on the valve, a restricted gear range.
Possible causes
- Solenoid coil open or shorted high
- Corroded connector or damaged internal harness medium
- Faulty output stage in the transmission control module low
Symptoms
- Check engine light on
- Restricted gears or fallback gear
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P08BD
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.