P08B8
Clutch Pedal Position Sensor B Circuit Intermittent/Erratic
P08B8 is intended for a second clutch pedal sensor whose signal drops out briefly or jumps without staying out of range. No manufacturer documents this code publicly. Ford, the only maker found to publish sensor B codes, lists just low (P08B6), high (P08B7) and the A/B comparison (P08B9) for its dual PWM pedal sensors, so short glitches there would most likely surface as a correlation fault; GM covers sensor A only. CARB requires circuit and plausibility monitoring of such inputs. Likely culprits are worn connector terminals or a wire fatiguing where the harness moves with the pedal. Sensor A's counterpart is P08AB. Drivers may see start-stop drop out now and then.
Possible causes
- Loose or worn terminals in the sensor B connector high
- Wire fatiguing where the harness flexes with pedal movement medium
- Sensor B producing glitches internally medium
Symptoms
- Start-stop dropping out intermittently
- Warning lamp that comes and goes
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P08B8
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.