OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P08B7

Clutch Pedal Position Sensor B Circuit High

P08B7 is set when the second clutch pedal sensor reports a value above its valid range. Ford uses it on vehicles with two PWM clutch pedal sensors, as listed in its 2020–23 gasoline OBD summary next to P08B6 (sensor B low), P08A9/P08AA (sensor A) and P08B9 (A/B correlation); the check is continuous and decides within one second. The clutch switch codes on the same page are marked non-MIL, the sensor codes are not. With a PWM output, high typically means the line is held at its pull-up level (100 % duty cycle), which points to an open signal or ground wire or a short to voltage. GM's published tables cover sensor A only. Effect for the driver: warning lamp, start-stop locked out.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number8 / B7

Possible causes

  • Open signal or ground wire of sensor B, leaving the input at its pull-up level high
  • Sensor B signal shorted to a voltage source medium
  • Failed clutch pedal position sensor B medium

Symptoms

  • Warning lamp on
  • Start-stop disabled
  • Sensor B reading pinned at maximum in scan tool data

Inspection / repair

  • Difficulty: easy
  • DIY: possible

What Pro shows you for P08B7

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication