P08B6
Clutch Pedal Position Sensor B Circuit Low
P08B6 means the signal of the second clutch pedal sensor has dropped below its valid range. Ford lists it in the 2020–23 gasoline OBD summary under dual PWM clutch sensors, together with P08A9/P08AA for sensor A, P08B7 for sensor B high and P08B9 for the A/B comparison; monitoring runs continuously and needs less than one second to flag a fault. Ford does not mark the code as non-MIL, unlike its clutch switch codes. For a PWM sensor, low usually means the output is stuck at ground (no pulses or 0 % duty cycle), caused by a short to ground, a lost supply or a dead sensor. GM's published tables have no sensor B. The driver mainly notices a warning lamp and missing start-stop.
Possible causes
- Sensor B signal wire shorted to ground high
- Lost supply voltage to sensor B (open wire, connector off) medium
- Failed clutch pedal position sensor B medium
Symptoms
- Warning lamp on
- Start-stop disabled
- P08B9 correlation code may set alongside
Inspection / repair
- Difficulty: easy
- DIY: possible
What Pro shows you for P08B6
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.