P08B4
Clutch Pedal Position Sensor B Circuit/Open
Some manual cars read the clutch pedal with two independent sensors so a single failure can be detected; Ford's 2020–23 gasoline OBD summary describes such a dual PWM layout. Sensor B is the second channel. P08B4 is the general circuit or open-wire fault of that second sensor. No manufacturer documents this code publicly: Ford uses only P08B6/P08B7 for sensor B plus P08B9 for the A/B comparison, and GM's tables cover sensor A alone. The code therefore rests on CARB's requirement to monitor such inputs for circuit faults. Sensor A's counterpart is P08A7. As long as sensor A is healthy the controller can usually still judge the pedal, but start-stop is often locked out until the fault is fixed.
Possible causes
- Loose connector or broken wire on the sensor B channel high
- Internal fault in clutch pedal position sensor B (often a shared housing with sensor A) medium
- Missing supply or ground for sensor B medium
- Faulty sensor B input in the engine control module low
Symptoms
- Warning lamp on
- Start-stop disabled
- Correlation code P08B9 may be stored as well
Inspection / repair
- Difficulty: easy
- DIY: possible
What Pro shows you for P08B4
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.