P08B0
Neutral Position Sensor B Circuit High
P08B0 reports that the signal of neutral position sensor B on a manual gearbox is above its upper electrical limit. With a three-wire Hall sensor this usually points to an open signal or ground wire or a short to voltage. No manufacturer documents P08B0 publicly. For the A sensor Audi does: the 2019–20 Q3 and 2022–23 A3 store P086D/P086E because the wires to sender G701 were too short and were pulled apart by shifting, fixed by lengthening them 20 mm; the same harness logic applies to a B sensor. A GM patent explains the dual-Hall neutral sensor with PWM output. CARB 1968.2 (e)(15) requires circuit monitoring. Low is P08AF; start-stop is typically off.
Possible causes
- Signal or ground wire pulled apart, harness too short high
- Signal wire shorted to voltage medium
- Sensor B open internally medium
Symptoms
- Start-stop does not switch the engine off
- Start system warning in the cluster
- Fault may come and go with gear changes
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P08B0
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.