OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P08AF

Neutral Position Sensor B Circuit Low

The signal of neutral position sensor B, the second neutral sensor or channel of a manual gearbox, has fallen below its lower electrical limit. Typical reasons are a signal wire shorted to ground, a missing sensor supply or a sensor without output. No manufacturer documents P08AF publicly; the A-sensor codes are documented by Audi (sender G701, three-wire Hall sensor) and by GM on the LT5 Corvette. A GM patent describes the sensor as two Hall elements on the shift shaft feeding a PWM signal to the engine module. CARB 1968.2 (e)(15) requires low/high circuit monitoring of such inputs. High is P08B0, the A-sensor equivalent P086C. Start-stop is usually blocked; the MIL status is left to the manufacturer.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number8 / AF

Possible causes

  • Signal wire chafed and shorted to ground high
  • Sensor supply open medium
  • Sensor B without output medium
  • Water or corrosion in the connector at the gearbox low

Symptoms

  • Start-stop no longer works
  • Start system warning in the cluster
  • Fault stored without driving complaint

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P08AF

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication