OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P08AC

Clutch Pedal Position Not Learned

The engine controller has to know at which pedal position the clutch is fully released or disengaged. GM teaches the fully applied position at the factory and then adapts it over time to clutch wear. P08AC is set when this learned value falls outside a window (LV7 1.4 L: 7–33 %, 2019 Corvette ZR1: 9–36 % of travel) or when the manufacturer's enable counter shows the learn was never completed; 250 ms loop, Type A, MIL after one trip. Before 2018 GM used P080A. After replacing the sensor, pedal parts, clutch or ECM, a relearn with a scan tool is needed; FCA, for example, issued a Renegade bulletin calling for a clutch pedal sensor learn. Circuit faults (P08A9/P08AA) must be cleared first.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number8 / AC

Possible causes

  • Relearn not performed after replacing the sensor, clutch parts or engine control module high
  • Learned position drifted out of the allowed window (worn clutch, wrong pedal stop, air in hydraulics) medium
  • Learn procedure aborted, for example by low battery voltage medium
  • Faulty or misaligned clutch pedal sensor preventing a valid learn low

Symptoms

  • Malfunction indicator lamp on
  • Start-stop, cruise control or automatic parking brake release not working as expected

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P08AC

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication