P08AB
Clutch Pedal Position Sensor A Circuit Intermittent/Erratic
P08AB is meant for a clutch pedal sensor A signal that jumps, drops out briefly or changes faster than a foot could move the pedal, without staying out of range long enough for the low or high codes. No manufacturer documents this code publicly. GM's published tables for the same sensor use only P08A8, P08A9, P08AA and P08AC, and its low/high checks need 400 of 500 bad samples, so short dropouts would go unnoticed there; Ford names only low, high and A/B correlation. CARB requires such inputs to be checked for circuit faults and plausibility. In practice the cause is usually a loose connector or a wire that breaks inside its insulation as the pedal moves. Start-stop and cruise control may cut out intermittently.
Possible causes
- Loose or worn terminals in the pedal sensor connector high
- Wire breaking inside its insulation where the harness flexes with the pedal high
- Worn sensor track causing signal dropouts at certain pedal positions medium
- Moisture or corrosion in the footwell connector low
Symptoms
- Start-stop or cruise control cutting out intermittently
- Warning lamp that comes and goes
- Erratic clutch pedal value in scan tool data while the pedal is held still
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P08AB
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.