OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P08A9

Clutch Pedal Position Sensor A Circuit Low

The sensor is designed with dead bands at both ends, so a signal near 0 V can only come from a fault. GM sets P08A9 when the signal stays below 4 % of the 5 V reference (low voltage or open circuit) for 400 of 500 samples taken every 12.5 ms, with the engine not cranking and system voltage above 9 V (10 V in some 2018 tables); Type A, MIL after one trip. GM used P0807 for this before 2018 and lists P08A9 for the LV7, the 2019 Corvette ZR1 and its 2018 OBDG04 engines. Ford's 2020–23 gasoline summary uses P08A9 for cars with dual PWM pedal sensors or a single analog sensor plus switches, detected in under a second. The high-side counterpart is P08AA; sensor B low is P08B6.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number8 / A9

Possible causes

  • Signal wire chafed through and shorted to ground in the pedal area high
  • Open signal wire or missing 5 V reference (connector off, broken wire) high
  • Failed clutch pedal position sensor A medium
  • Shared 5 V reference pulled down by another sensor on the same circuit low

Symptoms

  • Malfunction indicator lamp on after one trip
  • Start-stop and cruise control unavailable
  • Engine may refuse to crank on vehicles that release the starter via the sensor

Inspection / repair

  • Difficulty: easy
  • DIY: possible

What Pro shows you for P08A9

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication