P08A8
Clutch Pedal Position Sensor A Circuit Range/Performance
P08A8 flags a clutch pedal sensor whose signal is electrically valid but contradicts how the car is actually driving. GM uses it on manual cars since model year 2018 (before: P0806), e.g. the LV7 1.4 L engine and the 2019 Corvette ZR1 (LT5): when engine speed to output shaft speed shows that a gear is engaged and transmitting torque, but the pedal reads as pressed, the filtered position error must stay below 4 %. Enabled above 4.3 mph (LT5: 5.6 mph), not in 4WD low, torque above a table, no circuit, crank or speed sensor faults; Type A, MIL after one trip. Circuit faults are P08A9/P08AA. Typical result: start-stop and cruise control off, and the engine computer may misjudge clutch state.
Possible causes
- Sensor loose or misaligned on the pedal bracket, so its reading no longer matches pedal travel high
- Worn or drifting sensor track giving an offset signal medium
- Driver resting a foot on the clutch pedal, or a floor mat holding it down medium
- Corroded connector adding resistance to signal or ground low
Symptoms
- Malfunction indicator lamp on
- Start-stop and cruise control switched off
- Rev-matching or hill-start functions may be disabled
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P08A8
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.