OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P08A7

Clutch Pedal Position Sensor A Circuit/Open

Sensor A is the analog or PWM sensor that reports how far the clutch pedal of a manual car is pressed; the engine controller needs it for start-stop, cruise control, gear detection and starter release. P08A7 is the general circuit or open-wire fault of that sensor. No manufacturer documents this code publicly: GM folds an open circuit into its low-signal code P08A9, and Ford lists only P08A9/P08AA for sensor A. Saab's 2012 9-3 used the older P0806 as a comparable circuit fault (Check Engine, cruise control off). Range/performance, low, high and erratic faults have their own codes P08A8–P08AB. Expect a warning lamp and disabled start-stop or cruise control until the wiring or sensor is repaired.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number8 / A7

Possible causes

  • Loose connector or broken wire at the pedal sensor (pedal box wiring flexes with every clutch stroke) high
  • Internal fault in clutch pedal position sensor A medium
  • Missing 5 V reference or sensor ground medium
  • Faulty sensor input in the engine control module low

Symptoms

  • Malfunction indicator lamp on
  • Start-stop and cruise control unavailable
  • Engine may not crank if the starter release relies on the sensor

Inspection / repair

  • Difficulty: easy
  • DIY: possible

What Pro shows you for P08A7

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication