P08A6
Gear Lever Position Sensor System - Multiple Sensor Correlation
Here the module compares the combined gear lever position information with other evidence and finds no consistent picture. Two makers document it. FCA/Stellantis sets P08A6 in the PCM of 6-speed manual Jeeps such as the Wrangler JL as the all-gear-sensor check: the sensed gear is compared with a learned top-gear engine-to-road-speed ratio, so larger tyres trigger it until that ratio is relearned in sixth at 40–80 mph; a 4Low issue and software updates are also known, with MIL. Maserati's electronic shift module stores P08A6-64 for signal plausibility, leaving no gear selectable. Unlike P08A4/P08A5 it concerns the whole sensor system, not one sensor pair.
Possible causes
- Tyre size changed without relearning the top-gear ratio (FCA manual) high
- Control module software needing an update medium
- Modified transfer case gearing, fault only in 4Low low
- Internal fault or connector problem of the electronic shift module medium
Symptoms
- Check engine light
- Start-stop and gear indicator disabled, clutch overheat or service transmission message
- On shift-by-wire, no gear can be selected
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P08A6
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.