P08A5
Gear Lever Y Position Sensor 1/2 Correlation
P08A5 is the Y-axis twin of P08A4: the two redundant sensors that measure the selector lever's Y travel disagree beyond a calibrated limit. No manufacturer documents P08A5 publicly. In GM's electronic range selection the same check exists but is reported as range/performance: P08A0 sets when Y sensor 2 and Y sensor 1 differ by more than 12 % duty cycle, Type B. GM's patents show why redundancy matters: a disagreeing pair is resolved by trusting the more fault-tolerant signal, and if that is not possible the module selects neutral or park. CARB 1968.2 (e)(15) requires such rationality checks for inputs. For the driver this means a refused or held range; repairs usually replace the selector assembly.
Possible causes
- One of the two Y sensors drifting high
- Magnet carrier or lever mechanism shifted or worn medium
- Contact resistance on one sensor's signal path medium
Symptoms
- Shifter warning message
- Range selection refused or vehicle held in neutral or park
- Check engine light, depending on the manufacturer
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P08A5
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.