OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P08A2

Gear Lever Y Position Sensor 2 Circuit High

Y sensor 2 is the backup Hall sensor of an electronic selector lever and reports the lever's Y-axis travel as a PWM duty cycle. GM uses P08A2 in its electronic range selection and sets it when the duty cycle of Y sensor 2 rises above 88 % (2019 ECM and ICCM tables) or above 95 % (Cadillac XT4 2019, ECM tables 2023–2025); 3 failures in 4 samples at 25 ms, in later calibrations 10 of 12. A signal line shorted to voltage, an open ground or an internal sensor fault are the usual reasons. Type B, MIL after two trips. Range/performance and low are P08A0 and P08A1; sensor 1 of the same axis reports via P082D to P082F. With one sensor still valid, the lever stays usable.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number8 / A2

Possible causes

  • Sensor 2 signal wire shorted to supply voltage high
  • Sensor ground open or high resistance medium
  • Internal fault of sensor 2 in the selector assembly medium

Symptoms

  • Check engine light after two drives
  • Shifter warning message in the cluster
  • Range selection normally still works via sensor 1

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P08A2

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication