OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P08A1

Gear Lever Y Position Sensor 2 Circuit Low

The selector lever's Y-axis sensor 2 is one of two redundant Hall sensors that send the lever travel as a PWM duty cycle. GM documents P08A1 for its electronic range selection: the code sets when the measured duty cycle of Y sensor 2 drops below 17 % (2019 ECM and ICCM tables) or below 5 % (Cadillac XT4 2019, ECM tables 2023–2025), checked 3 of 4 samples at 25 ms or 10 of 12 in later years. Typical reasons are a signal wire shorted to ground, a missing sensor supply or a dead sensor output. Type B, MIL after two trips. Unlike P08A0 this is a pure signal limit, not a plausibility check; high is P08A2. Sensor 1 keeps the selector working.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number8 / A1

Possible causes

  • Sensor 2 signal wire shorted to ground high
  • Sensor supply open or connector backed out medium
  • Sensor 2 in the selector assembly without output medium
  • Connector corrosion from liquid in the console low

Symptoms

  • Check engine light after two drives
  • Shifter warning message in the cluster
  • Normally no change in driving, sensor 1 takes over

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P08A1

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication