OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P08A0

Gear Lever Y Position Sensor 2 Circuit Range/Performance

Sensor 2 is the redundant second Hall sensor that reports the Y-axis travel of an electronic selector lever as a PWM duty cycle. GM uses it in its electronic range selection (ECM and ICCM tables 2019–2025, Cadillac XT4 among them). P08A0 is set when sensor 2 reports a lever path outside the shifter gate (tolerance 5.5 %, ICCM 6–11 % of duty cycle), its frequency check fails, or it disagrees with Y sensor 1 by more than 12 %. Debounce is 3 of 4 samples at 25 ms (2025: 10 of 12). Type B, MIL after two trips. Low/High of the same sensor are P08A1/P08A2. GM's patent lets the other sensor carry on; only when both are invalid may the module ask for park.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number8 / A0

Possible causes

  • Sensor 2 in the selector assembly drifting or faulty high
  • Selector mechanism worn, bent or binding, lever leaves its nominal path medium
  • Loose contact or interference on the PWM signal line medium
  • Spilled liquid in the centre console low

Symptoms

  • Check engine light after two drives
  • Shift lever message or occasional unaccepted range selection
  • Usually still drivable, sensor 1 takes over

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P08A0

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication