P089D
Gear Lever X Position Sensor 2 Circuit High
Gear lever position sensor 2 is the redundant second sensor of an electronic selector lever, next to sensor 1 (P0821 ff), for the X or Y axis. The only documented user is GM's electronic range selection with PWM Hall sensors, as in the Cadillac XT4, and only for range, low and high. Following GM's patent, an invalid sensor is dropped and the other carries on; with both invalid the module can request park. GM sets P089D when the duty cycle of X sensor 2 rises above 88 % (2019) or 95 % (XT4 and 2025): open signal wire with pull-up, short to voltage or a sensor stuck high. Type B, MIL after two trips.
Possible causes
- Signal wire open (pull-up) or shorted to voltage high
- Sensor 2 faulty medium
- Sensor ground open medium
Symptoms
- MIL after two trips
- Gearbox or selector warning in the cluster
- Usually still drivable, sensor 1 takes over
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P089D
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 4 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.