P089B
Gear Lever X Position Sensor 2 Circuit Range/Performance
Gear lever position sensor 2 is the redundant second sensor of an electronic selector lever, next to sensor 1 (P0821 ff), for the X or Y axis. The only documented user is GM's electronic range selection with PWM Hall sensors, as in the Cadillac XT4, and only for range, low and high. Following GM's patent, an invalid sensor is dropped and the other carries on; with both invalid the module can request park. GM sets P089B when X sensor 2 reports a lever travel outside the gate (tolerance 5.5 % of duty cycle), its frequency is faulty, or it differs from sensor 1 by more than 12 %; 3 of 4 samples every 25 ms. Type B, MIL after two trips.
Possible causes
- Sensor 2 in the selector assembly faulty or drifting high
- Selector mechanism worn or bent medium
- Loose contact or interference on the PWM line medium
- Liquid in the console low
Symptoms
- MIL after two trips
- Range selection delayed or limited
- Only P available if both sensors fail
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P089B
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 4 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.