P0884
TCM Power Input Signal Intermittent
The TCM power input codes watch the supply voltage of the gearbox module or of its solenoid supply. Without a proper supply all solenoids go dead and the gearbox falls back to its hydraulic emergency gear with maximum line pressure: a fixed gear, harsh engagement, no shifting. Ford's external gearbox modules check a window of 9 to 16 V; GM reports the same under P0562/P0563. P0884 reports a brief loss of supply. Chrysler calls it 'power up at speed': the module notices on start-up that the vehicle is already moving, so it must have rebooted while driving. In field reports from NHTSA investigation PE07-027 on 2007 Jeeps it was stored after engine stalls, among others from an unlatched fuse box connector.
Possible causes
- Loose or unlatched connector at fuse box or module high
- Ignition switch or relay with contact dropouts medium
- Battery terminal or ground loose medium
- Internal module reset low
Symptoms
- Gearbox jerks or briefly enters limp mode while driving
- Engine may stall with a combined powertrain module
- Warning lamps flicker
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P0884
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 4 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.